Since1958 manufacture’s trust and actual results

1. Please remove cutting oil and scale before applying this agent.
2. Please make this agent into paint form by stirring. And paint evenly on the face of metals. (thickneess:2~3mm)
3. It takes 12~24hours for natural drying in a low humidity room after applying paint.
   In the case of enforced drying(about 200℃), it is dried for 20~30minutes after natural drying.
4. This agent is removed by hot water after quenching. (about 20minutes by around 90℃ hot water)

・Please keep the can’s up side down in a low temperature and humidity.
・The solvent become thick by volatilize in the case of repetitive closing motion of the can. Then, please add some water and stir it.

CK No.4: 5kg×6cans(30kg)

• Insufficient preliminary washing have a bad influence for prevent carburizing effect.
• If you use a lot of these agents, these may stuck on a smelting furnace.
• Inefficient stirring has a bad influence for prevent carburizing effect.
• You should paint this agent twice if you paint it for more than 2mm depth.
• This agent does not sink much. However, please stir it if you let it for more than 5minutes.
• Inefficient painting has a bad effect for prevent carburizing effect.
• The face of metals dries fast, but the inside takes some time.
• Inefficient drying has a bad effect for carburizing and a smelting furnace.
• Pouring a lot of dilution liquid has a bad effect for prevent carburizing effect.
• This agent dries slow on high humidity day by water’s effects.
• This agent may stripped and cracked by water’s effects.
• Please do heat treatment fast after confirm the agent is dry.
• Please pay attention for water’s effect if you dry it by force.
• This agent may freeze if you keep it at low temperature space. (less than 2℃)
• Shower cleaning is effective for this agent.